Vat Dyes Wet Friction Fastness Improver for Jeans

ALL ROUND WET RUBBING FASTNESS IMPROVER JV-555

Vat dyes Wet friction fastness improver for Jeans  

I. TECHNICAL INDICATORS

Appearance: light yellow to yellow transparent liquid

Ionic: weak cation

PH value: 4.5 ± 1 (pure water)

Solubility: easily dispersed in any proportion of tap water

II. MAIN COMPONENTS     

Special Waterborne Polyurethane

III. PRODUCT PROFILE

The wet rubbing fastness of active, vulcanized, direct and indigo dyes on cellulose fibers is especially low when they are thick and dark, especially the wet rubbing fastness of big black, big red, emerald green and so on is often lower than grade 1, while the wet rubbing fastness of textiles exported to Europe and America requires more than grade 3; the wet rubbing fastness can fully meet this requirement. This product improves the stability of salt and alkali on the basis of raw materials and reduces the shortage of the structure of the product itself.

IV. MAIN PERFORMANCE

1. Without formaldehyde and APEO, it belongs to environmental protection products.

2. It can greatly improve the wet rubbing fastness by 1-1.5 grades, reaching more than 3 grades.

3. It is easy to use, and it can be used directly with water.

4. The handle of the fabric is soft, and has no effect on the color light and sunlight fastness.

V. APPLICATION METHODS

According to the type and concentration of dyes used and the types and forms of treated fabrics, the usage is as follows:

1. Dip rolling method: 30-50g / L; glacial acetic acid / citric acid: 0.5-1.0g/l

Process: dyed fabric (pH ≤ 6.5) → dip and roll (rolling yield: 80-85%) → drying

2. Impregnation method (limited to water treatment plant)

Dosage: 2-4% (o.w.f.)

Bath ratio: 1:10 ~ 20

Process: dyed fabric (pH ≤ 6.5) → dipping (room temperature, time: 20 ~ 30min) → drying

VI. PACKAGING STORAGE

125kg / plastic barrel sealed at room temperature, shelf life of 6 months.

VII. POINTS FOR ATTENTION

1. Try to keep the pH value of working fluid in the range of 4.5-5.5.

2. The temperature of working fluid should be controlled between 25 ℃ and room temperature.

3. Before use, clean the cloth surface alkali (control pH ≤ 6.5), salt and soaping agent

4. Please use it immediately after preparation, and do a good job of sample test before use. The above process is only for reference.

5. It can only be used alone and can not be used in the same bath with silicone oil, softener, fixing agent and anionic auxiliary agent.

6. use a long time to produce a large amount of foam in the rolling tank. Remove foam or clean the groove and replace the working fluid before setting.

7. The water used for working fluid should be tap water ≤ 100ppm, and groundwater or river water should be treated and reused.

1. I don't know whether your product can be available, how can I order this from you?

It's the best way request sample from us,you test accord to our methods,and we will quote for you to check the cost.After confirmed,you can contact us to place a order.

2. After the sample passes the test, will the bulk also pass?

Since the sample is extracted from the mass cargo, the quality of the mass cargo and the sample can be guaranteed to be the same. As long as the fabric, proportion, drying temperature and mass cargo are the same when you make the sample, the effect will not be different.

3.What is your production capacity?

Now we have developed our manufacturing capacity to 5000MT per month.

4.How can we guarantee quality?
Always a pre-production sample before mass production;
Always final Inspection before shipment